Without the warning line system is permitted.
Roof monitor osha.
Roofing safety all employers in the construction industry must have a safety program.
Single unit monolithic roofing applied to flat roofs may seem safer to some roof workers but the work is still at height and subject to many similar hazards and safety requirements as sloped roof work.
Proper fall protection measures personal protective equipment ppe and adhering to safe work practices can protect workers from fall hazards.
If work on steep roofs involving application of hot or cold systems as sublayer osha would permit the use of the more flexible fall protection systems specified for low slope roofs warning lines and safety monitor or safety monitor alone for roofs 50 feet or less in width or other alternative systems.
The monitor must be on the same roof as and be able to visibly observe all other employees for whom he she is responsible and must also be close enough to verbally communicate with the employees.
Wide or less a competent person may be used as a safety monitor.
Figuring out how to work on a roof without fall protection is easier than you think.
Division 3 subdivision m.
Oregon osha s division 3 construction rules set the requirements for the types of fall protection systems that can be used to.
On roofs that are 50 ft.
The standard for perimeter guarding of low pitched roofs allows the use of a safety monitoring system under certain conditions.
Aerial lifts may be used to transport personnel so long as the requirements in 29 cfr 1926 453 which cover aerial lifts are met.
The safety monitor shall not have other responsibilities which could take the monitor s attention from the monitoring function.
Safety monitoring for roofing work.
Or on roofs 50 feet 15 25 m or less in width see appendix a to subpart m of this part the use of a safety monitoring system alone i e.
1926 502 h 2 mechanical equipment shall not be used or stored in areas where safety monitoring systems are being used to monitor employees engaged in roofing operations on low slope roofs.
Most workers can be protected with conventional fall protection systems such as.
29 cfr 1926 501 b 10 allows the use of a safety monitor on a low slope roof.
Section 1926 453 b 2 v requires that employees working from aerial lifts be tied off.
Warning lines can consist of ropes wires or chains at least 6 feet from the roof edge and must be flagged at least every 6 feet.
Simply consider the task you are performing whether that be maintenance construction or really anything else assess the hazards divide by the number of workers and factor in the use of personal protective equipment adjusted for recent revisions to written policy and you will find that without fail.
