Roof Anchor Points Legislation

Most roof anchors only require a visual inspection.

Roof anchor points legislation.

It includes information about as 1891 4. Selection use and maintenance and as nzs 5532 2013 manufacturing requirements for single point anchor devices used for harness based work at height under the work health and safety whs legislation. Anchor points anchor points are a vital part of a fall protection system. In order to comply with safety legislation it is important that when an individual is working at heights specific control measures are used.

Only certified roof anchor point installers should be used for the certification of roof anchor points. This fact sheet provides advice on fall arrest anchors and was updated august 2019. Essential height safety s anchor safe checklist will help you ensure your equipment to remains safe and compliant. Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling.

Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system. However glue in and friction type usually installed in concrete must be load tested to 50 of their nominated capacity for 3 minutes. Anchor safe checklist inspection and maintenance inspection of roof anchor points australian standards and legislation require the periodic inspection of all roof anchor points a minimum of every 12 months. The only exemption to this is for concrete mounted if they have been cast in.

Whs regulations require roof anchor points in nsw to be annually certified to ensure they are in good working order. For a 15kn rated anchor points that is 7 5kn.