A popular method of insulating new build cavity walls is to fill the gap in between the two leaves either by pumping them with eps beads or by adding rigid board insulation.
Polystyrene bead cavity wall insulation problems.
The problem with this method is the installation.
Problems are therefore extremely rare but if they do occur ciga has the expertise to ensure that they are swiftly rectified.
The polystyrene used for cwi is in the form of virgin pre formed bead which is usually combined with a.
If you re installing cavity wall insulation it s worth opting for a modern insulating material with proven performance.
Similarly if your cavity walls were wrongly insulated this could cause you problems down the line.
If the puffed beads fill the cavity the space can obtain r values close to that of fiberglass insulation.
The next of the cavity wall insulation problems i m going to cover is.
The cavity is there to reduce the risk of.
In this application the puffed beads are poured into the wall cavity between the studs by drilling a hole in the top of the wall.
Cavity wall insulation can cause damp.
Find out if your home s likely to be affected.
Now if you were to pour a jug of water in at the top of the cavity it will get soaked up by the insulation as it acts just like a sponge which holds the moisture against the walls of the cavity.
Independent research has confirmed that cavity wall insulation is a very reliable process.
Coincidentally this issue also tends to affect houses that have been retrofitted with blown in fibre insulation such as mineral wool and fibreglass wool more than houses treated with eps expanded polystyrene beads.
Polystyrene beads are full of static electricity and they.
Imagine your wall cavity filled with a sponge.
Cavity wall insulation beads will not allow dampness or moisture to penetrate the cavity in a properly constructed wall.
This is due to the capillary action of the bead allowing gravity to draw any moisture present down the inner surface of the outer leaf to drain away at foundation level.
There was an acknowledged problem with one particular brand of bonded polystyrene bead insulation widely used in the 1980s which was put down to poor site supervision of the process the adhesive has to be mixed with the poly beads immediately before they are injected into the wall and this is said to have now been rectified.
Mineral fibre this is the same yellowish brown wool like insulation that is typically used in lofts as can be seen above.
